Application settings of DentalCNC
Where are the settings of DentalCNC? Where can I configure machining?
The application settings of DentalCNC enable you to set important parameters which influence your machining workflow.
- Open the DentalCNC Application settings with the following icon in the main icon bar:
Like other features in DentalCNC, settings are machine-specific. If a specific setting doesn’t display, it is not available for your machine.
The DentalCNC application settings and local icon bar
The local icon bar for the sub-settings in the DentalCNC application settings
The DentalCNC application settings contains a local icon bar which offers you access to the following sub-settings:
General settings
Here you can specify general machining and software parameters.
Email notifications
DentalCNC can send you emails in case of important events. Here you can configure the email settings.
Current machine parameters
Here you can see the current values of parameters such as the incoming compressed air pressure, operating hours of the spindle etc.
Machine maintenance
Some maintenance tasks are machine-assisted. Here you can execute the corresponding functions.
Machining log
During machining, DentalCNC writes technical details about individual machining steps into log files. Here you can view these machining logs.
Tool list
Here you can manually specify the maximum tool life for each supported tool.
Machine data
Here you can view machine data such as the machine serial number, unlock extra equipment
Physical component which must be obtained separately and which adds new functionality to your machine. and force a manual tool change for certain tool positions.
Additional general settings for service technicians
Here you can change additional general settings for service technicians.
