Applies to: dentalcam & dentalcnc 8.11

Entering the license key

I’m in the evaluation period, how can I change this? Where do I enter the license key?

dentalcam & dentalcnc require a license key to function properly. The license key is stored on the control unit of the machine for which the applications were licensed. Therefore, you need a license key for every machine.

  • New machines already have the license keys stored on their control unit.

  • If no valid license key is found, you can mill up to 50 jobs until the evaluation period ends.

License keys for version 7 or below are not valid for dentalcam & dentalcnc 8.

If no license key is stored in the currently connected machine, you enter the license key as follows:

  1. Start dentalcnc.
  2. Switch on the machine at the main power switch.
  3. Wait until the machine has referenced.
  4. Open the dentalcncApplication settings with the following icon in the main toolbar: 

  5. Open the Machine maintenance view with the following toolbar icon: 

  6. Select the following icon: 

    7. The view; icon for entering the license key marked orange

    • A window opens. dentalcnc prompts you to enter the license code for the connected machine.
  7. Enter the license code.
  8. Select the following icon: 
    • If the license key was valid, dentalcnc stores it in the machine. If the key was invalid, you'll receive a corresponding error message.
  9. If you receive an error message because the entered license key was incorrect, try entering it again. If it still doesn't work, contact customer service.