Applies to: DentalCAM & DentalCNC 8.09
Error code 24 – Not found measuring point
DentalCNC aborts the job and displays the error code.
There is an extended version of this troubleshooting guide available for vhf certified service employees:
Interactive troubleshooting guide
Did the tool in the spindle touch the measuring key during measuring?
Is the Z-axis blocked?
If the spindle doesn’t properly move up and down, the Z-axis is blocked.
Z-axis
Can you feel the measuring key’s pressure point when pressing it down?
How to check this:
- Open the working chamber door.
- Press down the measuring key.
- Verify that you can feel the pressure point.
Did the error occur with an S1 or S2?
Does DentalCNC detect that the measuring key is pressed down?
Did the error occur with a K3 or K4?
- If you use a K4 edition, select No.
Recommendation
The axis needs repairing.
- Contact customer service.
Recommendation
The issue requires further investigation by a technician.
- Contact customer service.
Recommendation
In case of a failed test, you can find further recommendations in the linked description of the test function.
- If this doesn’t solve the issue: Contact customer service.
Recommendation
- Restart the job.
- If the problem persists: Contact customer service.
Recommendation
The measuring key may need repairing.
Recommendation
- Restart the job.
- If the problem persists: Contact customer service.
Recommendation
The electronic measuring circuit must be measured.
- Contact customer service.
Recommendation
The measuring key may need repairing.
- Contact customer service.
