Error code -7 – Tool removed during process

Did the spindle pick up the tool correctly via the collet chuck?

Has the tool been pulled out of the collet chuck? Is the collet chuck defective or soiled?

Are all tools correctly seated in the tool magazine? Are the tool magazine inserts intact?

If the tool magazine inserts are worn, tools will not sit properly in the magazine positions.

Exemplary illustration of a correctly inserted tool

Did you use the correct tools for the job? Did you mount the correct blanks for the job?

You can use the following information in DentalCNC to determine which tools are required:

The required tools in the 'Job details' section of the Machining view

Did you use the correct tools for the job? Did you mount the correct blanks for the job?

You can use the following information in DentalCNC to determine which tools are required:

The required tools in the 'Job details' section of the Machining view

Recommendation

• Contact customer service.

Recommendation

If tool magazine inserts are too worn for the tools to be properly inserted, you need to replace the inserts.

1. Replace the tool magazine inserts as described in the machine’s operating instructions.
2. Drill tool positions into the new tool magazine inserts.

3. Restart the job.

Recommendation

1. Remove the tool from the collet chuck.

2. Clean the collet chuck as described in the machine’s operating instructions.

3. If the collet chuck is defective or too soiled to be properly cleaned, exchange it for a spare collet chuck.

4. Restart the job.

Watch the video

YouTube video – When viewing this video, personal data is sent to YouTube, LLC, USA. Privacy statement

Recommendation

1. Exchange all broken and damaged tools.
2. Exchange all incorrect tools.
3. Replace all incorrect blanks.
4. Restart the job.

Recommendation

• Contact customer service.